The Gaui 330X-S UAV protection kit is supplied in kit form with all components required to complete the build . This guide will show you step-by-step how to complete it. It is designed as an illustrated reference - we recommended that you also closely follow the Gaui instructions included in the kit.
Tools needed:, size 0 screwdriver, ruler, scissors or craft knife and CA glue as option.
RC Helicopter - ESky Honey Bee V2 - CP3 - Belt-CPX - 2.4G - GAUI 500X QuadCopter - 425 X5 - Walkera Genius CP - M120D01 - E-flite Blade 450 MCPX
Gaui 330X-S Protective Frame Kit- Assembly Guide
1.Remove the landing gear.
2.Remove the aluminum post below the motors.
3. Insert aluminum posts into small holes in the sponge wedges.
4. Fit the sponge wedges into the ends of the frame extensions. Position the two yellow wedges in the forward facing frame extensions - to aid visual orientation when flying.
5.After the four sponges are fitted it should look like this.
6. Insert long aluminum post into protective sponge (about 25mm deep) these may be glued in place to add rigidity.
7.Insert the other end of the tubes into the sponge wedges (acting as landing gear).
8.
9.Cut the white plastic tubes to a length of 260mm.
10. Insert the 260mm tubes between the split in the ends of the protective sponges.
11. Completed picture of assembly.
11. Crash testing the Gaui 330X protection frame - don't try this at home!
Buy the 330X Protection Frame here - Buy the Gaui 330X-S here
View Basket
Recover Basket
